Loading...
Serving North Richland Hills, TX and surrounding areas. (817) 479-5107
You want a backyard that feels private and a fence that does not lean after the first rainy spring. We install wood and privacy fences built for North Texas clay soil and storm season - posts set deep, permits handled, and no mess left behind.
Wood and privacy fence installation in North Richland Hills means setting posts deep in concrete for local clay soil, pulling the required city permit, and completing most residential jobs in one to three days, with full debris removal included.
A wood privacy fence is still the most popular choice for North Richland Hills homeowners who want a backyard that feels like their own space. Cedar handles Texas heat and humidity better than most materials, and a well-built fence on properly set posts can last 15 to 20 years with routine maintenance. If you are not sure whether wood or vinyl fits your situation better, we also install vinyl fences and can walk you through the comparison - wood has a warmth and character that vinyl cannot match, but vinyl requires no maintenance at all.
We handle the permit with the City of North Richland Hills, call Texas 811 to mark buried utilities before digging, remove your old fence if needed, and clean up completely when the job is done. You do not need to manage any of that on your own.
If one or more sections tilt away from vertical, the posts have likely shifted in the soil. In North Richland Hills, this is especially common after a summer drought followed by heavy rain - the clay soil contracts and expands dramatically and can push posts out of alignment. A leaning fence will not self-correct; it gets worse over time and usually takes a section of fencing down with it eventually.
When boards are visibly cracked down the grain, split at the ends, or pulling away from the rails behind them, the wood has weathered past simple maintenance. North Texas summers are hard on unprotected wood, and boards that have been through several years of 100-degree heat without sealing often reach this point faster than homeowners expect. At this stage, replacing individual boards is usually less cost-effective than a full replacement.
A privacy fence should block the view into your yard. If you can stand inside and clearly see your neighbor's yard through gaps between boards, the fence has either warped significantly or was not built with tight spacing to begin with. This is a sign that the wood has dried and shrunk beyond recovery, and the fence is no longer doing the job it was installed to do.
North Richland Hills sees strong spring and summer storms that knock down fence sections, especially at corners and gate openings. If a recent storm left you with a downed section or a gate that no longer closes, that damage often signals the rest of the fence is not far behind. Rather than patching the failed section, it is worth having the whole fence line assessed to see what is actually worth saving.
The most common choice here is a board-on-board cedar privacy fence - solid panels with boards that slightly overlap, giving you a clean look from both sides and a little more wind resistance than a flat-face style. Cedar is naturally rot-resistant and holds up to North Texas summers without chemical treatment, which is why it has been the go-to wood fence material in this area for decades. If your budget points toward pressure-treated pine, we build those too - just plan to seal or stain within the first year and re-coat every two to three years to get the most out of it.
We also build wood fences alongside other outdoor projects. If you are putting in a screened-in porch or a covered deck, adding a perimeter fence at the same time is efficient and saves you a second mobilization cost. And if you have been considering vinyl instead of wood, our vinyl fence installation page covers that option in full detail - zero maintenance and a 20-to-30-year lifespan are hard to argue with for some homeowners.
Best for homeowners who want maximum privacy, a natural wood look, and a fence that holds up through North Texas weather cycles.
A clean, traditional look for yards where solid enclosure matters and curb appeal is a priority.
Suits homeowners who want a wood fence at a lower upfront cost and are willing to maintain it with periodic sealing or staining.
A good fit for front yards or decorative boundaries where defining the property line matters more than full enclosure.
Most of the housing stock in North Richland Hills was built between the 1960s and 1990s, which means a lot of original fences in this city are past or near the end of their useful lives. When those fences come down and get replaced, the contractor has to deal with the same challenge every time: Tarrant County clay soil. That soil does not forgive shallow posts or poor concrete work - it will push a fence out of alignment within a few years if the installation was not done right for local conditions. We set posts to the depth this soil demands, not to the minimum a generic install guide recommends.
The permit and HOA process here is also something a locally experienced contractor handles far more smoothly than an out-of-area company. North Richland Hills has city code requirements on fence height and setbacks, and many neighborhoods layer additional HOA rules on top of those. We have installed wood fences throughout Richland Hills and Keller as well, and the permit process across these nearby communities is something our crews navigate regularly. Getting the paperwork right before the first post goes in the ground protects you from problems that can be costly and stressful to fix after the fact. For authoritative guidance on how wood holds up in this climate, Texas A&M Forest Service publishes research on wood performance in Texas conditions.
When you reach out, we will ask a few basics - roughly how much fencing you need, whether there is an existing fence to remove, and whether you know of any HOA rules or easements on your property. We reply within one business day and schedule a time to come out and take measurements.
We walk your property line, measure the total footage, note where gates need to go, and check for anything that could complicate the job - tree roots, slopes, or existing concrete. You receive a written proposal that breaks down cost by materials and labor, so you know exactly what you are paying for.
We pull the permit from the City of North Richland Hills and call Texas 811 to have buried utility lines marked before any digging begins. This step usually takes a few business days. Once the permit is approved, we confirm your installation date - nothing starts until the paperwork is in order.
The crew removes the old fence if applicable, bores post holes, sets posts in concrete, and attaches rails and boards. Most residential jobs wrap up in one to three days. When complete, we walk the finished fence with you, check that gates swing and latch correctly, and haul away all old materials and debris.
Free estimate, no pressure. We handle the permit, utility locate, and cleanup.
(817) 479-5107We set posts to the depth required for Tarrant County clay soil - not just the national minimum. Shallow posts in this soil are the primary reason wood fences in this area lean and fail early. Getting the post depth right is the foundation of a fence that lasts, and it is the first question you should ask any contractor who quotes your job.
We handle the North Richland Hills permit application, coordinate the Texas 811 utility locate, and build the approval timeline into your installation schedule. You do not have to track the permit status or figure out the development services process - we manage it from start to finish so your fence gets built the right way and stays documented.
We use cedar that is suited to North Texas conditions - a material Texas A&M Forest Service research consistently recommends for its natural rot and insect resistance in this climate. We also advise you on when to apply a protective sealant so your investment holds up for the long haul.
One of the most common fence disputes in established North Richland Hills neighborhoods happens when a fence goes in a few inches over the property line. We confirm your boundary markers before installation begins. If there is any uncertainty, we tell you before we dig - not after a neighbor complains. You get a fence that is yours, on your land, with no surprises.
Each of these details adds up to a fence that stands straight, stays on your property, and does not send you back to the contractor for repairs within the first few years. That is what a proper wood fence installation in North Richland Hills looks like.
Add an enclosed outdoor living space to your home - often built alongside a perimeter fence for a complete backyard transformation.
Learn MoreZero-maintenance fencing in privacy, picket, and rail styles - a strong alternative for homeowners who want a clean look without periodic upkeep.
Learn MoreCrews fill up fast once the weather warms - reach out now and lock in your installation date before the rush.